Hoof-Tite Block Adhesive

This product is used to adhere wooden or rubber blocks to the claw of a bovine hoof to relieve pressure on the opposite claw. Two-part urethane, fast-set adhesive. Features a dual chamber to reduce cross contamination. Saves time and money with an innovative, no-mixing system. Features a time-saving push-off top with a snap-on tip; highly efficient, reduces extra product waste

• Sets fast; 30 seconds.
• No curing; no mixing.
• Easy airtight reseal minimizes mess and waste.
• No cutting required to open new cartridge system.
• Apply in a well-ventilated area or outdoors.
• Avoid contact with skin and eyes.
• One-year shelf life.
• Made in the USA.
• Keep out of reach of children.
• Preserve unused product: Squeeze tabs together and replace plug.

Treat the injured claw. Then trim the sound claw as flat, clean and dry as possible. Place the Hoof Tite cartridge into the applicator gun. Squeeze tabs on the green plug and pull to remove. Place mixer tip into place. Slide cap onto mixer tip and twist cap to secure. Dispense through gun.

Apply adhesive to wood, plastic or boot blocks. Apply block immediately to prepared sound claw. Hold firmly for 30 seconds. Avoid pressing glue between hoof and block, because the layer of glue may become too thin. After setting, let the cow stand on the block for 2 to 3 minutes before releasing.